Vol. 50 No. 8 CONTENTS
Special Issue on

General Paper

Special Issue on (Vol.50 No.8)

Original Paper (Vol.50 No.8)

Influence of KCl on the Hydration and Strength Development in Alite-KCl System

Harutake IMOTO, Etsuo SAKAI, Akinori NAKAMURA and Masaki DAIMON

807

Some Properties of Concrete Incorporated Sludge

Junji NAKAMOTO, Kazuo TOGAWA and Yoshitaka MITSUIWA

812

Studies on Utilization of Coarse Fly Ash to Concrete

Seiichi NAGAOKA, Kikuo TACHIBANA, Kenji WATANABE, Nobuo UEHARACMitsuhiro ISHII, Hironobu MURAI and Shinji KAWASAKI

818

Estimate of Dosage of Superplasiticizer in Self-Compacting Concrete Using High-Volume Fly Ash

Yoshitaka MITSUIWA, Junji NAKAMOTO and Kazuo TOGAWA

824

Studies on Corrosion Prevention of Reinforcement with Types of Rust-Inhibitors

Hiroyuki SAKAKIBARA, Akio SUGIURA, Kenji MIYAWAKI, Keiiti OSAKI and Sigehiro KOBAYASHI

830

A Study on a Technology for Producing High Quality Recycled Coarse Aggregate

835

The Investigation about the Application of the Recycled Aggregate to the Base Course Material

Hiromichi MATSUSHITA, Hiroaki TSURUTA, Atsushi KUBONO, Satoshi FUJIMOTO and Seiichi TANIMOTO

843

A Study on Relationship between Condition of Placing on Consolidated Fresh Concrete and Occurrence of Cold Joint

Hiromichi MATSUSHITA@and@Yoshihiro SUE

851

Corrosion Cell Formation Pattern and Rate of Steel Corrosion Induced by Carbonation in Concrete with Defects

Nobuaki OTSUKI, Shin-ichi MIYAZATO and Hayato KIMURA

857

Effect of Placement and Compaction on Carbonation of Concrete and Corrosion of Steel at Cold Joint

Takehiro SAWAMOTO, Masanori TSUJI and Yutaka KIMACHI

865

Improvement in Water Resistance of Macrodefect-Free(MDF)Cements by Application of Hot Press Molding Process

Yoshihiko OHAMA, Toshimitsu KOBAYASHI and Katsunori DEMURA

873

Load Carrying Behavior of RC Member Strengthened with CFRP Sheet Subjected to Reinforcing Steel Corrosion

Takashi YAMAMOTO, Atsushi HATTORI and Toyoaki MIYAGAWA

877

Flexural and Shear Behavior of Reinforced Concrete Beams Damaged by Alkali-Silica Reaction under Reversed Cyclic Loads

Susumu INOUE, Yasuhiro MIKATA, Kazuo KOBAYASHI and Tamotsu NIEDA

883

Influence of Welding Heat on Low Yield Strength Steel

Yoshinobu ONO, Atsumichi KUSHIBE, Hirofumi KANEKO and Takatoshi OGAWA

889


General Paper (Vol.50 No.8)

Original Paper (Vol.50 No.8)

Relationships Between Surface Roughness Indexes and Tensile Bond Strength Between CFRP Sheets and Concrete

Masakazu MITSUI, Kimio FUKUZAWA and Tatsuya NUMAO

895

Role of Ions in GaAs Film Growth on Si Substrates by Mixed Beams of Ions and Molecules

Susumu TAMURA

901

Strain in GaP Films Heteroepitaxially Grown on Si

Kazuhiro NAKAMURA, Takashi FUYUKI and Hiroyuki MATSUNAMI

904

An Experimental Study of TRIP Behavior in a Cr-Ni-Mo-Al-Ti Maraging Steel -Evolution of TRIP Strain and Back Stress

Kiyokazu NAGAYAMA, Takaki TERASAKI, Kikuaki TANAKA, F.D. FISCHER and G. CAILLETAUD

908

Tension Creep of Surface Layer and Compression Creep of Inner Layer Perpendicular to the Grain in Sugi Boxed-Heart Square Timber

Noboru FUJIMOTO , Kazuki TACHIWANA , Kazuhiro OOUCHI and Yoshihiro MATAKI

914

Effect of Pre-Crack Size and Testing Temperature on Fatigue Strength Properties of Crack Healed Mullite

920

Lecture (Vol.50 No.8)

Aim at Environment Friendly Composites‡T:Outbreak and Control of Composite Material Waste

Takuji KOYANAGI

926