Vol. 52 No. 10 CONTENTS

Original Paper (Vol.52 No.10)

Change in Surface Morphology and Water Vapor Permeation with Elongational Deformation of Silicate/PVA Thin Layer on Nylon 6 Film by Sol-Gel Method

Tadakazu TSUKAMOTO, Motoo KAWASAKI, and Hideki YAMANE

1147

Effect of Firing Atmosphere on Electrical and Spectroscopic Properties of Barium Titanate Ceramics Codoped with La and Mn

Nobuyuki TAKEUCHI, Yuji ABIRU and Shingo ISHIDA

1155

Measurement of the Anisotropic Elastic Constants of CVD Diamond Film and Micromechanics Modeling

Nobutomo NAKAMURA, Hirotsugu OGI, Tetsu ICHITSUBO, Masahiko HIRAO, Natsuki TATSUMI, Takahiro IMAI and Hideaki NAKAHATA

1160

Fracture and Microscopic Deformation on (0001) and (1010) in Sapphire Single Crystals due to Repeated Indentations

Shinzo KOBAYASHI ,Yasushi UESUGI and Sei MIURA

1166

Continuous Observation of Tensile Deformation of Polycrystalline Titanium by Scanning Probe Microscope

Yan LI, Takeji ABE and Naoya TADA

1174

Martensitic Transformation of Titanium-Rich NiTi Prepared by Rapid Solidification

Hitoshi MATSUMOTO and Nobuyuki ISHII

1180

Superplasticity under Combined Loading Conditions and Its Constitutive Equations

Masataka TOKUDA, Tadashi INABA, Akira KURAKAKE, Satoshi IKUSHIMA and Yu CHEN

1186

Metallo-Thermo-Mechanical Simulation of Jominy Test Procedure Introducing Developed Material Database "MATEQ"

Tatsuo INOUE and Yoshihiro MORIMOTO

1192

Identification of Transformation Plasticity Coefficient by Four-Point Bending Tests and Some Data under Pearlite Transformation

Takayuki OTSUKA and Tatsuo INOUE

1198

Fatigue Limit Diagrams of Tufftrided Spheroidal and Flaky Graphite Cast Irons

Hiroshi HOHJO, Akira YAMADA and Katsushi SARUKI

1204

Self-Healing of Creep Cavities Formed in Austenitic Stainless Steel

Junro Kyono and Norio Shinya

1211

A Study on Dislocation Movement and Stress Field near Fatigue Crack Tip by Discrete Dislocation Dynamics

Yasuko MOTOYASHIKI, Atsushi SUGETA, Yoshihiko UEMATSU and Masahiro JONO

1217

In-situ Local Stress Measurement near Notch Tip in Alumina Ceramics Using Synchrotron Radiation Source

Yoshihisa SAKAIDA, Keisuke TANAKA, Yoshiaki AKINIWA and Yozo SAWAKI

1225

X-Ray Evaluation of SiO2/Cu/TiN Films Deposited by Ion Plating

Tatsuya MATSUE, Takao HANABUSA, Yasukazu IKEUCHI and Kazuya KUSAKA

1231

A Method of X-Ray Stress Measurement of Silicon Single Crystal

Keisuke TANAKA, Yoshiaki AKINIWA, Kenichi MIZUNO and Kaori SHIRAKIHARA

1237

Development of Ramie Fiber Reinforced Biodegradable Resin Matrix Composites by Press Forming and Effect of Chemical Treatments

Koichi GODA, Takashi ASAI and Tatsuya YAMANE

1245

Fatigue Damage Evaluation of GFRP Using Infrared Thermography -Effects of Matrix Resin and Fiber Content on Evaluation of Fatigue Damage-

Ken KURASHIKI, Qing-Qing NI and Masaharu IWAMOTO

1253

Effect of Fiber Distribution on Elastic-Viscoplastic Behavior of Long Fiber-Reinforced Laminates

Tetsuya MATSUDA, Nobutada OHNO, Hiroki TANAKA and Toshihiro SHIMIZU

1258

An Elasto-Plastic Constitutive Model for Sand and Its Application to Compacted Sandy Ground

Fusao OKA, Kazuaki HIOKI, Takeshi KODAKA and Hirohisa YAMADA

1265

Lecture (Vol.52 No.10)

Recent Topics on Rock Engineering ‡V:Development of Rock Mechanics in Southeast Asian Countries

Hiroyasu OHTSU

1271