Introduction of Compressive Residual Stress into Titanium Alloy Ti6Al4V by Cavitaion Shotless Peening
Hitoshi SOYAMA, Dan ODHIAMBO and Shankar MALL
Singular Stress Distributions near the Edge of Interface of Bonded Dissimilar Materials with an Interlayer
Seiji IOKA, Keiji MASUDA and Shiro KUBO
An Evaluation of the Adhesive Toughness of Cu Thin Film on Si Substrate
Masataka HASEGAWA, Shigenori SUZUKI, Shoji KAMIYA@and Masumi SAKA
Evaluation of Crack Initiation at the Coroer of the Interface between Sub-Micron Films on the Basis of Fracture Mechanics Concept
Tadahiro SHIBUTANI, Qiang YU, Masaki SHIRATORI and Tetsu Tsuruga
Evaluation of Interfacial Adhesion Strength between Brittle Thin Film and Polymer Substrate
Masaki OMIYA, Hirotsugu INOUE, Kikuo KISHIMOTO, Masaaki YANAKA and Noritaka IHASHI
Effect of Rolling Contact Fatigue on Delamination Strength of WC-Co Coating Sprayed by HP-HVOF
Chengwei LI, Masahiko KATO, Bo ZHANG and Keijiro NAKASA
Influence of Debonding Damage on Elastic and Elastic-Plastic Singular Fields around a Crack-Tip in Particulate-Reinforced Composites
Keiichiro TOHGO and Takanori ITOH
Specimen Thickness Effect on Cleavage Fracture Toughness of High and Intermediate Pressure Steam Turbine Rotor Materials
Hiromi UEMURA, Akira KIUCHI, Takao INOUE and Atsushi WAKAMI
Near-Threshold Fatigue Crack Growth Behavior at High Temperature in a Vacuum in SUS304
Masahiro TSUJI, Akira SATO, Tokutsugu MINAMI, Kota IMANISHI and Shiro KUBO
Shear Fracture and Slip Weakening Behavior on Granite under High Pressure and High Temperature Water Conditions
Toru TAKAHASHI and Toshiyuki HASHIDA
Evaluation of Mode I Crack Growth in Rock
Kazushi SATO and Toshiyuki HASHIDA
Quantitative Evaluation of Closed Cracks on the Surface of Stainless Steel by Microwaves
Yang JU, Toru MIYADU, Yasuhiro UCHIMURA, Hitoshi SOYAMA and Masumi SAKA
Quantitative Analysis of Stretched Zone Width Based on Difference of Fracture Surface Roughness
Masahiro TAKANASHI, Satoshi IZUMI, Shinsuke SAKAI and Naoki MIURA
