Vol. 56 No. 7 CONTENTS
Special Issue on
Special Issue on X-ray Study of Mechanical Behavior of Materials
General Paper

Special Issue on Special Issue on X-ray Study of Mechanical Behavior of Materials (Vol.56 No.7)

Foreword

Y.Akiniwa

587

Original Paper (Vol.56 No.7)

Residual Stress in Zirconia Coating by EB-PVD Method

Kenji SUZUKI, Kunihiko WADA, Hideaki MATSUBARA, Takahisa SHOBU, Masashi KAWAMURA and Keisuke TANAKA

588

X-Ray Stress Measurement of Nickel-Base Single Crystal Superalloy Using Two-Dimensional PSPC

Shutarou MACHIYA, Keisuke TANAKA and Yoshiaki AKINIWA

594

Change of X-Ray Elastic Constants of Carbon Steel Caused by Quenching and Effect of Its Change on X-Ray Stress Measurement

Yoshihisa SAKAIDA and Kosuke TANAKA

602

Measurement of Residual Stress Induced by Laser Irradiation on Grain Oriented Silicon Steel Using X-Ray Diffraction

Kazuyuki SUEYOSHI,Koichi AKITA,Shin-ichi OHYA,Hiroshi SUZUKI,Muneyuki IMAFUKU and Keiji IWATA

609

Distortion and Residual Stress Behavior of Super-High Frequency Induction Hardened Carbon Steel Bar with Small Diameter

Daisuke SUZUKI, Koji YATSUSHIRO, Seiji SHIMIZU, Yoshio SUGITA, Motoki SAITO and Katsuhiko KUBOTA

615

X-Ray Microbeam Evaluation of Domain Switching near Fatigue Cracks in Piezoelectric Ceramics (PZT)

Keisuke TANAKA, Yoshifumi IWATA, Tokinori NAKAGAWA, Yoshiaki AKINIWA and Hidehiko KIMURA

622

New Stress Measurement Method of Thin Plate Using Transmission Dffracted X-Rays

Jun-ichi SHIBANO, Michiaki KOBAYASHI, Setsuo MIURA, Tomoyuki HIRATA and Masahiro NISHIKAWA

629

Thermal Relaxation of Residual Stresses in Multi Hard Films Deposited by Arc Ion Plating

Tatsuya MATSUE, Takao HANABUSA and Yasukazu IKEUCHI

635

X-Ray Stress Measuring Technique for a Side-Wall of Deep Groove

Taizo OGURI, Kazuo MURATA and Katsumi YAMAGUCHI

641


General Paper (Vol.56 No.7)

Original Paper (Vol.56 No.7)

Numerical Analysis on Compressive Deformation Behavior of Porous Polymer with High Initial Relative Density

Isamu RIKU and Koji MIMURA

647

Deformability of Several Granitic Rocks and Gabbros in Uniaxial Tension

Weiren LIN, Manabu TAKAHASHI, Yukiyasu FUJII, Satoshi NISHIYAMA and Takato TAKEMURA

654

Multiaxial Creep-Fatigue Damage Evaluation of SUS304 Stainless Steel at High Temperature

Shengde ZHANG and Masao SAKANE

660

Suggestion of Evaluation method for Adhesion of DLC Films Using Scratch Test and 180 Degree Bend Test

Morimasa NAKAMURA,Ken-ichi MIURA, Takashi MATSUOKA,and Tomoko HIRAYAMA Morimasa NAKAMURA,Ken-ichi MIURA, Takashi MATSUOKA,and Tomoko HIRAYAMA

667

Lecture (Vol.56 No.7)

The Frontier of Risk-Based Engineering V:Risk Perceptive Society and Risk-Based Engineering

Akihiko SUZUKI

675