Vol. 63 No. 5 CONTENTS
Special Issue on
Composite Materials
General Paper

Special Issue on Composite Materials (Vol.63 No.5)

Foreword

Q-Q.Ni

355

Original Paper (Vol.63 No.5)

Synthesization of CNTs on Pore Surfaces in C/C Composites and Effect of CNTs on Tribological Characteristics

Kiyotaka OBUNAI, Kazuya OKUBO and Toru FUJII

356

Experimental Method for Dynamic Compression Behavior of Composite Laminates Using SHPB Technique

Takayuki KUSAKA, Takanori KONO, Yasutoshi NOMURA and Hiroki WAKABAYASHI

362

Effects of Fiber Reinforcing Configuration on Oxidation and Melting Phenomenon of CF/PPS Laminated Composites by Electrically-conducting

Daiki TANABE, Kazuaki NISHIYABU and Tetsusei KURASHIKI

368

Development and Performance of Pitch Based CFRP Damping Composites

Takuo HASHIDUME, Shinichi TAKEMURA,Toshiaki NATSUKI and Qing-Qing NI

374

Dry Fabric Forming Analysis Considering the Influence of Tensions on In-plane Shear Behavior

Masato NISHII, Tei HIRASHIMA and Tetsusei KURASHIKI

380

Estimation Method of Fatigue Life Distribution for Woven Composites Based on Numerical Analysis of Damage Development

Kazutaka MUKOYAMA, Koushu HANAKI, Tetsusei KURASHIKI and Koichi KAIZU

386

Effect of PVA treatment on Specific Flexural Strength and Modulus of Stampable Sheet Fabricated with Bamboo Fibers

Junko KOIKE , Kazuya OKUBO and Toru FUJII

394


General Paper (Vol.63 No.5)

Original Paper (Vol.63 No.5)

Influence of Co on Strength and Microstructure of Cu-Ni-Co-Si Alloy

Kotaro IZAWA, Atsushi OZAWA, Kazuhisa KITA, Chihiro WATANABE and Ryoichi MONZEN

401

In-Service Residual Stress Measurement Technique with Tow-Dimensional X-Ray Diffraction for Weld Metal in Structural Components

Yun WANG, Hisamitsu HATO, Toshikazu KIKUCHI and Atsushi CHIBA

409

Lecture (Vol.63 No.5)

Introduction of Biomaterials for Beginners
‡T: Present Condition of Biomaterials and Its Application

Noriyuki HISAMORI

417