Influence of High-Pressure Hydrogen Exposure on Increase in Volume by Gas Absorption and Tensile Properties of Sealing Rubber Material
Junichiro YAMABE, Masatoshi NAKAO, Hirotada FUJIWARA and Shin NISHIMURA
Abstract:When a rubber O-ring was used as a sealing material of a pressure vessel for high-pressure hydrogen gas such as 70 MPa, which is the hydrogen pressure for fuel cell electric systems, the O-ring was extruded from the pressure vessel due to an increase in volume by gas absorption, and consequently cracks initiated in the previous study. Therefore, it is important to clarify the influence of hydrogen pressure on the increase in volume and mechanical properties in order to design the rubber O-ring for high-pressure hydrogen gas. From this viewpoint, unfilled and carbon black-filled sulfur-vulcanized NBR composites were exposed to hydrogen gas at a maximum pressure of 100 MPa; then, the influence of hydrogen exposure on volume increase and tensile properties of the composites was investigated. The residual hydrogen content which was measured 35 min after decompression increased with an increase in the hydrogen pressures ranging from 0.7 to 100 MPa for the unfilled composite (NF) and the filled composite (CB). In contrast, the volume of NF and CB was hardly changed less than 10 MPa, and the increase in volume by gas absorption was observed more than 10 MPa. The elastic modulus of NF and CB decreased with an increase in volume, and this tendency can be successfully explained in term of the decrease in the crosslink density and elongation by volume increase. Although the tensile strength of NF hardly depended on the volume of specimen, the tensile strength of CB clearly decreased with an increase in volume. This is considered to be because a boundary structure between carbon black and rubber matrix was changed by hydrogen exposure. Key Words:Hydrogen, Rubber, Elastomer, Tensile properties, Hydrogen embrittlement, Gas absorption, Swelling