Vol. 51 No. 6 CONTENTS
Special Issue on
Ceramic Material
General Paper

Special Issue on Ceramic Material (Vol.51 No.6)

Original Paper (Vol.51 No.6)

Preparation and Characterization of TiO2 and Apatite Coated Photocatalyst

Shinji KATO, Misao IWATA and Toru NONAMI

599

Lattice Defect in Polished Sapphire and Precise Measurement of Local Strain

Tomohiro SAITO, Hiroshi KAWAMOTO, Takahisa YAMAMOTO and Yuichi IKUHARA

604

Effect of Mechano-Chemical Treatment on Consolidation of CaSiO3 by Carbonation

Haruhisa SHIOMI, Yuko Takada, Takeshi SHIONO, Makoto KITAMURA,Takashi Oosugi and Masataka KAMITANI

610

High Temperature Deformation and Dislocation Structure of ƒ¿-Al2O3 Single Crystals

Atsutomo NAKAMURA, Takahisa YAMAMOTO and Yuichi IKUHARA

617

Thermal Cyclic Fatigue of Porous Ceramics for Hot Gas Filters

asushi MATSUSHIMA, Satoshi KITAOKA, Hideo AWAJI, Chun-Hong CHEN, Jianwu CAO, Fusayuki NANJO, Hiroshi MUTO, Shinji IKEDA and Yushuke TADAKUMA

622

Residual Thermal Stresses in Multilayered Functionally Graded Material Plates

Gang JIN and Hideo AWAJI

628

State of Silver in Ag2O-B2O3-Al2O3 Glass and Its Change by Heat Treatment

Takashi WAKASUGI, Atsushi KOTANI, Teppei KATSUMATA, Katsuhisa TANAKA and Rikuo OTA

633


General Paper (Vol.51 No.6)

Original Paper (Vol.51 No.6)

Preparation and Structural Control of Porous Hydroxyapatite

Teisuke SATO, Tatsuo BESSHI, Toshinari KORI, Atsuo HATANO and Junji TAMATANI

637

Titania Aggregates Formed by Hydrolysis of Ti(OH)4-HCl-H2O Concentrated Solutions

Keiji DAIMON, Kouki HORIBA, Yang GUANG, Yasuo HIKICHI and Toshitaka OTA

642

A Trial to Prevent the Inpreferable Effect of Local Cellular Fomation in Microstructurally-Controlled Ni-Base Superalloys Subjected to Previous Damage on High Temperature Fatigue Strength -For Refurbishment and Recoating Technology-

Masakazu Okazaki, Reki Takaku, Toshio Suzuki, Kouichi Namba and Yoshio Harada

647

A Stochastic Analysis of Temperature and Thermal Stress in Functionally Graded Plates with Randomly Varying Initial Temperature

Yoshihiro SUGANO and Ryoichi CHIBA

653

The Extension Behavior of Parallel Cracks Based on the Energy Release Rate Criterion

Takahiro ABE, Chikayoshi YATOMI, Ken-ichi HASHIMOTO and Syouji YAMAMOTO

659

Crack Extension Behavior in the Brittle Material under Compression Mixed Mode Loadings

Takahiro ABE, Chikayoshi YATOMI, Yoichi SUZUKI and Kazuhiko TSUJINO

666

The Effects of Air Atmosphere/High Vacuum/Inner Environment of Materials on Fatigue Fracture Surfaces of High Strength Steel

Takahiro SHIINA, Takashi NAKAMURA, Toru NOGUCHI and Fuyuki HOSOKAWA

673

Identification of Material Constants in Constitutive Equation by Indentation Test with Different Indenters

681

Deposition of Amorphous ITO Thin Film at Low-Temperature by Inclined Opposite Target Type DC Magnetron Sputtering Method

Wu JINGBO, Ri-ichi MURAKAMI, Masaharu KONDO and Yun-Hae KIM

688

Effect of Bias Voltage and Discharge Current on Mechanical Properties of TiN Film Deposited by D.C. Magnetron Sputtering

Hirotaka TANABE, Yoshio MIYOSHI, Tohru TAKAMATSU and Hideyuki SUGIURA

694

Lecture (Vol.51 No.6)

Materials Science Toward "Super-" and "Ultra-" High Temperature Technologies ‡U:Materials and Ultra Long Term Elevated Temperature Strength for Ultra Super Critical Energy Components

Yoshiatsu SAWARAGI and Fujio ABE

701