Vol. 51 No. 10 CONTENTS
Special Issue on
Aggregates and Admixtures for Concrete
General Paper

Special Issue on Aggregates and Admixtures for Concrete (Vol.51 No.10)

Original Paper (Vol.51 No.10)

Effect of Aggregate on Concrete Strength under Tri-Axial Load

Hideaki TANAKA, Hironori OGURA, Takehiro SAWAMOTO and Masanori TSUJI

1067

Safety Measures of Concrete Structures Using Fiber Reinforced Concrete|Prevention for Falling Concrete Pieces

Yasushi KAMIHIGASHI, Syoji NOJIMA, Koichiro SHITO, Yoshio UCHIDA and Toyoaki MIYAGAWA

1073

Fundamental Study on Properties Estimation Method of Concrete in Consideration of the Distribution of Coarse Aggregate Quality

Tatsuhiko SAEKI, Yasuhiko Inoguchi, Yasuhiro NIINO and Shigeyoshi NAGATAKI

1079

Use of Chinese Sand and Fine Powders of Industrial Waste as Fine Aggregate

Akira YOSHINO, Shoichi INOUE, Tamotsu KURODA and Shinsaku MATSUI

1086

Development of Aggregate Materials Using Industrial Wastes -Aiming at the Zero-Emission-

Yoshiyuki MOMIYAMA, Junji UCHIDA, Takahiro SHITAMA, Yasuhiro NARASAKI and Hiroyuki MIZUGUCHI

1092

Effects of Particle-Size Characteristics of Limestone Powder on Flowability of Self-Compacting High Performance Concrete

Masanori BABA, Ryou OH, Ryouichi KAWANAKA, Toshiki AYANO and Kenji SAKATA

1099

Applicability of Crush Stone Powder and Recycled Concrete Powder to High-Fluidity Concrete

Takayuki FUMOTO and Masaru YAMADA

1105

Mix Proportion Theory of Strength Controlling Concrete Containing Large Quantity of Coal Ash

Yasunori MATSUFUJI, Tomoyuki KOYAMA and Korekiyo ITO

1111

Influence of Portland Blast-Furnace Slag Cement and Air-Entraining and High Range Water -Reducing Admixture on Some Properties of Concrete Incorporating Sludge

Junji NAKAMOTO, Kazuo TOGAWA, Yoshitaka MITSUIWA and Toshiyuki TANI

1117

Fire Resistance of Polypropylene Fiber Reinforce Concrete

Masuo YABUKI, Mahmoud Abo El-Wafa Ahmed, Toshiki AYANO and Kenji SAKATA

1123

Development of Highly Water-Resistant Gypsum-Based Composites

Shinsuke KUMAGAI and Yoshihiko OHAMA

1129


General Paper (Vol.51 No.10)

Original Paper (Vol.51 No.10)

Study of Effective Factor on Fatigue Strength of (+) Dual Phase Stainless Steel by Shot Peening Process

Shigenobu TAKAHASHI, Munetoh HASHIMOTO, Kouichi HIRATSUKA and Yukio HIROSE

1135

Development of Design System for Keyboard Rubber Diaphragms

Tei HIRASHIMA and Masaru ZAKO

1141

Numerical Analysis and In-Situ SEM Observation of Damage Development for Woven Fabric Composite Materials

Yasutomo UETSUJI, Masaru ZAKO and Kazuaki NISHIYABU

1147

Effects of the Grain Size on Friction and Wear Properties of ZK60 Magnesium Alloy

Takashi MATSUOKA, Kazuhiko SAKAGUTHI, Toshiji MUKAI, Masakazu MATSUYAMA and Ryo YOSHIOKA

1154

Deposition of ZnO Film by Using an Atomospheric Pressure Cold Plasma Generator

Yoshifumi SUZAKI, Seiki EJIMA, Tomokazu SHIKAMA, Osamu TANAKA, Takahiro KAJITANI and Hideomi KOINUMA

1160

Mechanical Properties of Heat-Treated Natural Fibers

Shinji OCHI, Hitoshi TAKAGI and Ryusuke NIKI

1164

Lecture (Vol.51 No.10)

Impact-Load Behavior of Materials and Its Evaluation Techniques T:Evaluation of Impact Strength of Composite Materials

Kinya OGAWA

1169